Call now to get tree support such as tree clearance, tree cutting, bush digging, shrub removal, stump chop and lots of other within USA:


Call us now

Call us now +1 (855) 280-15-30










Quick Links: What lift will be best for my use?

Oct 15, Keep the jack under the rear end. Do one end of a single spring at a time, removing the bolt securing the spring into the front pocket and/or the leaf spring and frame bolts on the rear shackle as required. This keeps the rear end properly located.

Log in or Sign up.

3. Remove the bolt and lower the jack completely to perform the repair described below. Product description. The OTC A Truck Front Leaf Spring, Pin and Bushing Service Set delivers 10 tons of hydraulic force to remove and install truck front spring eye bushing assemblies quickly and easily.

Services bushings with diameters from /4 inch through /8 inch and pin diameters from 7/8 inch through /8 inch/5(29). Duralast Leaf Spring Bushing/Bolt . Part # SKU # Limited-Lifetime Warranty.

check if this fits your vehicle. check if this fits your vehicle. Both the front and rear eye of the front and rear spring uses the same bushings. In one end bushing is a steel encased rubber bushing. There is a steel inner sleeve, then rubber, then a steel outer shell. This outer shell is only about 1/16″ thick. The best way to remove these bushings is Estimated Reading Time: 1 min.

Dec 29, Most all can be done without removing springs. I can knock out a Pete low air leaf spring bar pin bushings on a tandem in less than three hours. The tool is a must on KW rubber steer axle shackle pin/bushings. I have the OTC pin and bushing press for steer axle, but KW ones need the whole 20 ton of the Tiger tool. Bronze Bushings. Replace worn or damaged leaf spring bronze bushings with these replacement bushings.

Measure the dimensions of your old bushings to determine the correct part number that you need. Remember to grease your pins to prolong bushing life and performance.

But honestly, the best way really is to burn them out.

Bronze Leaf Springs. Oct 26, The rear suspension under some classic Chevys is supported by a pair of leaf springs made up of multiple leaves (strips) of spring steel. Typically, they will have three or four individual leaves that make a set of springs. Leaf springs have a specific curvature when they come from the factory, and this curvature and the number of leafs in the spring pack, determines the load capacity and the.

Feb 17, WULF 2" Rear Lift Add-A-Leaf Lift Kit compatible with Toyota Tacoma 2WD 4X4Pro-Lift TD Double Pin Jack Stand - 6 Ton, 18x12" (Pack of 1).