Call now to get tree support such as tree clearance, tree cutting, bush digging, shrub removal, stump chop and lots of other within USA:


Call us now

Call us now +1 (855) 280-15-30






Also, follow the instructions to a T.

Apr 22, clean out old bushing hole w clean rag. very lightly oil outside of new bushing. align sight roll pin hole with appropriate part of sight/slide. gently push new bushing in so that is is just held in with friction and properly squared up to the slide. holding slide in hand with the bushing facing downward, tap the bushing and slide on a piece of wood until fully seated. Missing: Watertown MA. CGW’s precision barrel bushing can improve your CZ’s accuracy for a fraction of the cost of other barrel bushing systems.

The goal is to remove any movement from the barrels muzzle at lock up.

This is precisely what the CGW X does.

This is precisely what the X CGW barrel bushing does. Barrel is removed just like stock without having to remove the bushing. The X is heat Missing: Watertown MA. I wanted to swap out the factory bushing on my CZ 75b SA with the Cajun Gun Works 10x barrel bushing.

Got the front sight pin removed. Took the front sight out (replacing the sights).

My search skills leave a lot to be desired

Then I soaked the bushing already in the slide of the pistol, with some WD. Put the slide in a deep freezer at a temperature of 40 degrees bushclear.buzzg: Watertown MA.

CZ factory 1/2x28 threaded heavy SP barrel in 9mm. Only fits SP manual safety, decocker, Shadow 1 and Phantom with barrels utilizing a" diameter.–Missing: Watertown MA. Here's a little tip for removing a tight barrel bushing (barrel to bushing fit) without bushclear.buzz shows the slide stop with the"log man" modification for e Missing: Watertown MA. May 22, Cajun Gun Works (CGW) 10x Barrel Bushing.

«on: April 13,PM». First off, WOW! I installed one of these on my non-ACCU Bushing CTS 40s and immediately saw a difference/reduction in barrel to slide movement. The removal of the old bushing and installation of the new bushing took me about 15 bushclear.buzzg: Watertown MA. Jun 24, The 10X bushing may make no difference at all if your existing bushing is still good. I've had replacement bushings put into two CZs. The first was a custom tool steel bushing put into a CZ 75B SAO upper.

It replaced the worn bushing" of slop) and cut group sizes from 3" at 15 yards to the same hole at 15 bushclear.buzzg: Watertown MA.