Call now to get tree support such as tree clearance, tree cutting, bush digging, shrub removal, stump chop and lots of other within USA:

Call us now

Call us now +1 (855) 280-15-30

What's new New posts New media New resources Latest activity.

Jun 04, 1. Shift rod clip tool; 2. Bushing removal and installation tool; 3. 2 new nylon bushings - (comes with a pouch of synthetic grease) 4.

PDF Instructions; White bushing measures: (In the groove) mm OD, mm ID, width mm. Here is what happens to these bushings when they get old and tired Estimated Reading Time: 4 mins. Dec 27, Simply tap the bushing a few turns, use the puller and it slides right out. I even reuse the bushing as I don’t think the few little threads inside do any harm. Basically after the bushing is set on the o ring the o ring becomes the guide for the shaft, just hafta set it at the right"feel" for bushclear.buzzted Reading Time: 8 mins.

Sep 15, Re: Removal Tool For Shift Rod Bushing I used a 5/16" rod cut from my kids old crib. Ground one end down to a 1/4" taper and it has worked everytime. No need to trash the bushing. And even if you do thread the bushing it will still work. The only thing it is doing is holding the O ring in.

The condition of the bushing is not that bushclear.buzzted Reading Time: 7 mins. Park Tool Folding Hex Wrench Set (mm)Park's Hex Wrench Set offers all the popular Allen wrenches (, 2,3, 4, 5 and 6mm) in a convenient fold-up unit. The tool tips are chamfered for a positive grip and the one-piece fiber-reinforced-resin handle is light, comfortable, slip resistant and 40% stronger than steel.

Oct 20, Re: replacing shifter bushing o ring 77 johnson 25 hp. yes, you will need to remove the lower unit and then split the gearcase to remove the shift rod. I don't know if I would attempt to remove the bushing though. Try using a couple of"picky" tools like those a dentist uses and with a little patients you can pick the old o-ring bushclear.buzzted Reading Time: 2 mins. Aug 03, The last gearcase I re sealed was on my ’62 Johnson It leaked at the shift rod o-ring and around the bushing as well as prop shaft seal, drive shaft seal around the shafts and the seal bores, the vent plug washer and the drain plug washer.

The only thing that didn’t leak was the spaghetti seal. Everything got a good dose of on that. late fall trees, 2149 Everett MA